Axis M31-VE Serie Guia De Instalacion página 9

AXIS M31-VE Network Camera Series Installation Guide
Mount camera with adaptor (for cabling through the wall, and mounting on stand)
1. Slide the camera's Ethernet cable through the
cable slot. Adjust the cable so it snaps into the
hole.
2. Press the appropriate cable lid into the slot in
the side of the adaptor.
3. Fasten the adaptor with four screws appropriate
to the surface material.
4. Follow steps 5-7 above.
Adjust the direction of the lens
Fit the lens tool to the lens holder, and adjust the position of the lens by pointing the lens tool
handle in the preferred direction (See illustration on page 6). This can be done vertically from 0 to
90 degrees (ensure weather shield is not blocking the view), and 30 degrees to the left or the right
on either side in increments of five.
The lens holder can also be rotated to adjust the image.
Align the ribs in the lens tool horizontally so that the image is also aligned
horizontally.
Note:
The '0' mark on the lens holder indicates the bottom of
the image and the '180' mark indicates the top, See
Hardware overview
, on page 6. If the camera is mounted
upside down, adjust so the '0' mark is on top and the
'180' mark below the lens.
The line inside of the bottom of the optic holder should
be aligned with the line at the center of the optic mount.
All manuals and user guides at all-guides.com
cable slot
cable hole
cable lid
Align ribs horizontally
Page 9
line
line