Electricity Supply - GYS Smartmig 110 Manual De Instrucciones

DEScRIPtIoN
Thank you for choosing this machine. To get the best from your machine, please read the following carefully :
The SMARTMIG 110 is a traditional machine for semi-automatic welding of flux cored wire only (AC current).
Adjustment and Setting of this machine is easy with its SMART feature.

ElEctRIcItY SUPPlY

This machine is supplied with a 16A plug (type CEE7/7). The absorbed current (I1eff) is indicated on the device at
maximum usage.
The Smartmig 110 must be connected to a 230V 1PH with EARTH protected by a 10A circuit breaker.
DEVIcE PRESENtAtIoN (FIG-I)
1- Wire speed regulator
2- Control panel and table for SMART feature
3- Power Switch Off/On
4- Voltage selection
5- Power cable
SEmI-AUtomAtIc WElDING FoR StEEl (FIG-II)
Machine only suitable for Ø0.9 gasless (cored) wire welding (see picture II - A).
Gasless (cored) wire does not require gas for welding.
Machine is set-up for welding Ø0.9 gasless wire (contact tube, roller and torch sheath supplied specifically for this
application). The roller is specific to this machine and has two grooves, a U shape and a V shape. It is recommended
to use the U shape groove for gasless welding.
PRocESS oF REEl AND toRch ASSEmblY (FIG-III)
Remove the Nozzle (fig III-E) from the torch by turning clockwise and then remove the contact tip, leaving the sup-
port
and the spring on the torch (fig III-D).
• Open the door of the machine
FIG III-A : Position the reel on to the support.
• Adjust the reel break (2) to avoid reel movement tangling the wire when welding stops. Be careful not to tighten
too much - the reel must rotate without straining the motor.
• Tighten the plastic screw (3).
FIG III-B : Installing the drive roller.
FIG III-C : To select the adjustment of the drive rollers, proceed as follows :
• Loosen the drive roller knob as far as possible.
• Insert the wire until it exits the other side by about 2cm, tighten the knob again slightly.
• Start the motor by pressing the trigger of the torch.
• Tighten the knob (fig III-C) whilst pressing the trigger until the wire starts to move. Nb : When welding with Aluminium, use the minimum possible pressure to avoid crushing the wire
• Leave approximately 5cm of wire out of the end of the torch, then attach the contact tip suitable for the wire used,
and then the nozzle (fig III-E).
The SMARTMIG 110 can accommodate 100mm diameter wire reels.
Below are the different combinations possible :
DIREctIoNS FoR USE (FIG IV)
The SMARTMIG feature allows you to adjust the voltage and the wire speed.
• The voltage (button A/ B)
• Wire speed - adjust the regulator (1) to the colour zone indicated.
Examples :
To weld 1.0mm thick steel :
• Move button (2) to the « A » position
• Move the regulator (1) to the zone of lightest colour and adjust « by sound » if required
All manuals and user guides at all-guides.com
Smartmig 110
6- Fixed torch
7- Fixed earth cable
8- Drive Reel
9- Wire Reel Support
10- Handle
Smartmig 110
No Gas 0,9
EN
7