Choosing A Location For Installation; Electrical Connection Requirements; Installation - Argo DUAL 14 DCI R32 Manual De Instalacion Y Uso

 Use the specified cable types for electrical connections between indoor and outdoor
units. Securely lock the cables so that their terminals do not receive external stress.
 Electric cables with insufficient capacity, incorrect cable connections and insecure
cable terminals may cause electric shock or fire.

Choosing a location for installation

Essential requirements
Do not install the unit in the following locations.
Otherwise, a fault may occur.
1. Locations with extreme heat sources or
flammable or explosive gases or vapours.
2. Locations with high-frequency devices (e.g.
welding machines, medical equipment).
3. Locations close to coastal areas.
4. Locations with oils or fumes in the air.
5. Locations with sulphide gas.
6. Other locations that have special conditions.
Do not operate the unit in the immediate vicinity
of laundrettes, bathtubs, showers or swimming
pools.
Outdoor unit
1. Choose a location where the noise and airflow produced by the outdoor unit will not annoy neighbours.
2. The location should be well ventilated and dry; the outdoor unit must not be exposed to direct sunlight
or strong winds.
3. The site should be able to support the weight of the outdoor unit.
4. Check that the installation complies with the requirements of the dimensional drawing for

installation.

5. Choose a location out of the reach of children and away from animals or plants. If this is not possible,
install safety fencing.

Electrical connection requirements

Safety precautions
1. Electrical safety standards must be met when installing the unit.
2. Use a power supply circuit and circuit breaker that comply with local safety regulations.
3. Make sure that the power supply matches the requirements of the air conditioner. An unstable
power supply or incorrect wiring may result in a fault.
switching on the air conditioner.
4. Correctly connect the live, neutral and earth wires to the power outlet.
5. Disconnect the power supply before carrying out any work on the electrical circuit or carrying
out any safety work. For models with a plug, make sure the plug is easily accessible after
installation.
6. Do not connect the power before installation is complete.
7. Do not use the appliance if the power cable or plug are damaged. If the power cable is damaged
it must be replaced by the manufacturer, retailer or other qualified person to avoid a hazard.
8. Since the temperature of the cooling circuit is high, keep the interconnecting cable away from
the copper pipe.
9. The unit must be installed in accordance with national wiring regulations.
10. Installation must only be performed by trained individuals in accordance with regulations.
V 07/21
Indoor unit
1. There should be no obstructions near the air
inlet or outlet.
2. Choose a location where the condensate can
drain out easily without causing a nuisance.
3. Choose a convenient location to connect the
outdoor unit to the power outlet.
4. Choose a location out of the reach of children.
5. The site should be strong and solid enough to
support the weight of the indoor unit and prevent
noise or vibration.
6. The unit should be installed 2.5 m from the floor.
7. Do not install the indoor unit directly above
electrical equipment.
8. Try to keep a certain distance from fluorescent
lights.
Install suitable power cables before
29