Adjusting The Microphone Angle; Appendix; Troubleshooting; Error Messages - Pioneer MVH-AV285BT Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installation
2 Mount the microphone on the steering column.
1
2
1 Double-sided tape
Install the microphone on the steering column, keeping it
away from the steering wheel.
2 Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
Keeping it away from the steering wheel.
Adjusting the microphone
angle
The microphone angle can be adjusted.

Appendix

Troubleshooting

If you have problems operating this product, refer to this section.
The most common problems are listed below, along with likely
causes and solutions. If a solution to your problem cannot
be found here, contact your dealer or the nearest authorised
Pioneer service facility.
Problems with the AV screen
The screen is covered by a caution message and the video
cannot be shown.
 The handbrake lead is not connected or applied.
— Connect the handbrake lead correctly, and apply the
handbrake.
 The handbrake interlock is activated.
— Park your vehicle in a safe place and apply the handbrake.
The audio or video skips.
 This product is not firmly secured.
— Secure this product firmly.
No sounds are produced. The volume level will not rise.
 Cables are not connected correctly.
— Connect the cables correctly.
The picture is stretched, with an incorrect aspect ratio.
 The aspect setting is incorrect for the display.
— Select the appropriate setting for that image.
iPod cannot be operated.
 The iPod is frozen.
— Reconnect the iPod with the USB interface cable for iPod /
iPhone.
— Update the iPod software version.
 An error has occurred.
— Reconnect the iPod with the USB interface cable for iPod /
iPhone.
— Park your vehicle in a safe place, and turn off the engine.
Turn the ignition key back to off (ACC OFF). Then restart
the engine, and turn the power to this product back on.
— Update the iPod software version.
 Cables are not connected correctly.
— Connect the cables correctly.
Problems with the phone screen
Dialling is impossible because the touch panel keys for
dialling are inactive.
 Your phone is out of range for service.
— Retry after re-entering the range for service.
 The connection between the mobile phone and this product
cannot be established now.
— Perform the connection process.
Problems with the Application screen
A black screen is displayed.
 While operating an application, the application was ended
on the smartphone side.
— Press
to display the Top menu screen.
 The smartphone OS may be awaiting screen operation.
— Stop the vehicle in a safe place and check the screen on
the smartphone.
The screen is displayed, but operation does not work at all.
 An error has occurred.
— Park your vehicle in a safe place, and then turn off the
ignition switch (ACC OFF). Subsequently, turn the ignition
switch to on (ACC ON) again.
The smartphone was not charged.
 Charging stopped because the temperature of the smart-
phone rose due to prolonged use of the smartphone during
charging.
— Disconnect the smartphone from the cable, and wait until
the smartphone cools down.
 More battery power was consumed than was gained from
charging.
— This problem may be resolved by stopping any unneces-
sary services on the smartphone.

Error messages

When problems occur with this product, an error message
appears on the display. Refer to the table below to identify the
problem, then take the suggested corrective action. If the error
persists, record the error message and contact your dealer or
your nearest Pioneer service centre.
31
Tabla de contenido
loading

Tabla de contenido