Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Step 7: Shut Down
1 . Release spray gun trigger and let engine idle for one
minute .
2 . Push engine switch to OFF (0) position .
WARNING! Spray gun traps high water pressure,
even after engine shut down and water
disconnection, which could result in serious
injury .
3 . Point spray gun in safe direction . Press trigger lock
and depress trigger to relieve high water pressure .
Step 8: Clean Up
1 . Turn off water and purge system .
2 . Disconnect and drain all hoses, spray gun and spray
wand .
3 . Empty pump of all liquids by pulling recoil handle
about six times .
NOTICE If storing in freezing temperatures or more than
30 days, see Storage.
Maintenance Schedule
Follow the hourly or calendar intervals, whichever occurs
first . See the engine operator's manual for instructions on
how to properly maintain the engine .
Every 8 Hours or Daily (see Operation Section)
• Check engine oil level
• Clean debris
• Lubricate o-rings
• Check spray gun
• Check high pressure hose
• Check / clean water inlet screen
• Check detergent siphoning tube / tank
General Recommendations
Regular maintenance will improve the performance and
extend the life of the pressure washer . See any authorized
dealer for service .
Pump Oil
Do not attempt any oil maintenance on this pump . The
pump is pre-lubricated and sealed from the factory,
requiring no additional maintenance for the life of the
pump .
Detergent Siphoning Check Ball
The check ball in detergent siphoning system may become
stuck from dried soap or minerals in water . The check ball
can be freed by performing the following:
WARNING! Chemical Burn Hazard . Chemicals
could cause burns resulting in death or serious
injury . Follow chemical manufacturer's label
instructions for proper use and handling of the chemical .
Following Shut Down, remove detergent siphoning hose
from barbed fitting on pump .
1 . Insert paper clip, or similar device, into barbed fitting
on pump and push down until ball moves .
2 . Reinstall detergent siphoning hose .
Spray Tip Maintenance
Clean an obstructed spray tip to correct a pulsing
sensation when squeezing the spray gun trigger .
1 . Following Shut Down, remove spray tip from spray
wand .
2 . Use a paper clip, or similar device, to free foreign
material .
Engine Maintenance
See the engine operator's manual for instructions on how
to properly maintain the engine .
Common Service Parts
Pump Saver™ . . . . . . . . . . . . . . . . . . . . . . . . 6039
O-ring Maintenance Kit . . . . . . . . . . . . . . . . 705001
Water Inlet Screen . . . . . . . . . . . . . . . . . . B2384GS
Engine Oil Bottle . . . . . . . . . . . 100005 or 100028
Contact an authorized service dealer or
BRIGGSandSTRATTON .com for a full list of parts and
diagrams .
Maintenance
11
Tabla de contenido
Solución de problemas
