Steinberg Systems SBS-PW-30L Manual De Instrucciones página 18

MODE – weight unit selection (each key press shifts to the next unit)
STORE, M1 and M2 – reading value memory
1. Press the STORE key (do this only when the display shows "0").
2. The Total Price on the display should read "SAUE" (Save).
3. Enter the price using the numerical keypad.
4. Press M1 or M2. The value will be stored under M1 or M2.
ADD – value addition
1. Place an object on the checkweigher and enter the price (it will be shown in the
Unit Price on the display).
2. Press the ADD key, remove the object, and press any numerical key.
3. Place another object on the checkweigher.
4. Enter the object's price.
5. Press the ADD key.
You can add the values for up to 200 separate objects.
CLR – deletes all value inputs
PCS – piece counting
1. Press and hold PSC, and press MODE briefly to choose the quantity
(25/50/75/100).
2. Place the number of pieces selected in the previous step on the checkweigher.
3. Press the PSC key again.
4. Place the pieces to be counted again on the checkweigher.
5. The display will read the actual quantity.
3.3.3. DISPLAYED MESSAGES:
"O_Ld": overloaded
"LO": low battery
"Pass": calibration successful
3.3.4. CALIBRATION:
1. Turn on the checkweigher.
2. Simultaneously press and hold M1, M2, and PCS for 3 seconds. The display will
read 2 kg.
3. Press MODE to select 2, 5, or 10 kg.
4. Press the power switch to confirm the selection. The display will show "CAL" and
the selected value begins to flash.