Andis CLC-4 Instrucciones De Uso Y Cuidado página 4

OPERATING INSTRUCTIONS
Before starting your clipper, it must be pre-charged fully before using it for the first
time. To start clipper, slide the power switch to the on position; to stop, slide the
power switch to the off position.
CHARGING CLIPPER
This battery charger is intended for use with Andis model CLC-4 clipper. Remove the
clipper and AC/DC adapter from the carton. Plug the adapter into a 120V AC.
The clipper must be OFF for the battery to charge. Plug the adapter cord plug directly
into the bottom of the clipper. The clipper has a lithium-ion battery that cannot be
damaged by overcharging. We recommend that the clipper be unplugged if not in
use for seven or more days.
The clipper with a fully charged battery will operate for approximately 90 minutes of
continued use. A battery that is fully depleted will take approximately 120 minutes
to fully recharge.
BATTERY STATUS INDICATOR LIGHT
This clipper is equipped with a LED light to indicate battery and charging status.
When clipper is in use the light will turn green. When the battery is low and requires
charging, the green light will begin flashing. When the clipper is plugged in and the
battery is charging, the light will turn Red.
FAILURE TO CHARGE:
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Check to make sure adapter cord plug is plugged firmly into clipper. If failure to
charge still exists, return clipper to Andis or an Andis authorized service station for
examination and repair or replacement.
USE WITH CORD ADAPTER
If the clipper powers OFF while in use, the power cord can be directly attached to
continue use in corded operation. When the clipper is running with the power
cord attached, the green light will remain on, even if the battery is partially or fully
discharged. The clipper will not charge while in use with the cord attached.
4