Display Of Faults And Blocks - Ferroli CRONO REM Manual De Usuario

14. DIsPLay OF FaULTs aND BLOCKs

Two types of alerts are displayed by the Remote Control: FAULT and BLOCK.
FAULT
If there is a fault, the display shows the message <ERROR> blinking.
The fault is identified by an error code (the same also shown on the boiler display) followed by the letter E and cannot
be reset by the user.
BLOCK
If there is a fault, the display shows the message <ERROR> which alternates with >>OK.
The block is identified by an error code (the same also shown on the boiler display) followed by the letter E.
Press the button to reset the card and restore operation.
89
cod. 3542A970 - Rev 01 - 03/2022
EN