Basic Display; Operation Status - Ferroli CRONO REM Manual De Usuario

5. BasIC DIsPLay

When the modulating Remote Control is switched on, after the start-up procedure, the basic display page is activated.
The upper digits show the current time, the lower digits show the ambient temperature detected by the temperature
sensor integrated into the Remote Control, if AMBON = 1 [or the boiler flow setpoint (CH SL) if AMBON = 0 and CL
EN = 0 (see installer menu description)].
The other active icons depend on the operation status and on the ambient temperature management mode, as
described in the following paragraphs.

6. OPERaTION sTaTUs

From the basic display, use the button
The possible states are as follows.
Mode Icons Description
OFF Heating is disabled, whereas the instant DHW request remains enabled.
The frost protection function remains active, if enabled.
INV Winter mode: heat generation requests are active for both the heating circuit and DHW.
EST Summer mode: only the DHW circuit is active. Heating requests are inhibited.
70
EN
to change the operation status of the remote control.
cod. 3542A970 - Rev 01 - 03/2022