Operating The Controls - Waring Commercial WFP14SE Manual Del Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Disassembly when removing the S-blade

• Remove the work bowl from the unit by rotating clockwise (left) to

disengage the tabs on the bottom of the bowl platform from the

work bowl. When the bowl handle is on the left (about 7 o'clock

position), you can gently lift the bowl straight up and out.

It is recommended that you remove the bowl from the

motor base before you remove the S-blade.

• To remove the blade, keep a slight downward pressure on the top

of the center hub of the blade while removing the bowl from the

motor base. This will form a seal to prevent food particles from

spilling into the center tube of the bowl and onto the motor base

or the work surface. REMOVE ALL FOOD AND LIQUID BEFORE

REMOVING S-BLADE, OR THE BOWL WILL LEAK. Then remove

the S-blade from the bowl. Handle the S-blade with caution; the

blades are extremely sharp.

Disassembly when removing an accessory disc

• Do not remove the work bowl until the accessory disc is removed.

• To remove an accessory disc, place your fingers on the outer edge

of two opposite sides of the disc and lift. The disc should remove

cleanly. To remove the detachable stem, hold the disc in one hand

with the stem facing away from your hand. Be careful not to scrape

your hand on any sharp edges; depress the release switch with

your thumb and rotate counterclockwise.

• Remove the work bowl from the unit by rotating clockwise to

disengage the tabs on the bottom of the bowl platform from the

work bowl. When the bowl handle is on the left (about 7 o'clock

position), you can gently lift the bowl straight up and out.