Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The beeper
Normally, the multimeter beeps whenever certain conditions are met (for
example, the multimeter beeps when a stable reading is captured in reading hold
mode).
The beeper is factory set to ON, but may be disabled or enabled manually.
– Turning OFF the beeper does NOT disable the front panel keys beep tones.
– A beep tone is always emitted (even with the beep state turned OFF) in the
– In addition to the beep operations just described, when the beeper is ON, a
Keysight 34450A User's Guide
following cases:
– A continuity measurement is less than or equal to the continuity threshold.
– A SYSTem:BEEPer command is sent.
– An error is generated.
single beep occurs for the following cases (turning the beeper OFF disables
the beep for the following cases):
– When a new MIN or MAX value is stored
– When a new stable reading is updated on display for Math Hold operation
– When a measurement exceeds the HI or LO Limit value
– When a forward-biased diode is measured in the Diode function
Functions and Features
2
75
Capítulos
Tabla de contenido
