Stanley FATMAX SFMCE510 Manual De Instrucciones página 10

ENGLISH
Please visit our website www.stanley.eu/3 for further
information.
Accessories
This tool includes some or all of the following accessories.
The performance of your tool depends on the accessory used.
Stanley Fat Max accessories are engineered to high quality
standards and designed to enhance the performance of your
tool. By using these accessories you will get the very best
from your tool.
10 10
(Original instructions)
Precision plunge cut saw blade for
wooden materials, soft plastics.
(Part number - STA26105-XJ)
Separating, plunge and flush cutting
of wood and soft plastics. Ideal for
working on doors, skirting boards,
windowsills and flooring.
Plunge cut saw blade for wood and
metal.
(Part number - STA26110-XJ)
Separating, plunge and flush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions,
nails and screws.
Plunge cut saw blade for wood and
metal.
(Part number - STA26115-XJ)
Separating, plunge and flush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions.
Segmented saw blade.
(Part number - STA26120-XJ)
Long life blade which is ideal for
cutting wood, plastics, thin walled
ferrous and non-ferrous material.
Rigid scraper.
(Part number - STA26135-XJ)
Ideal for removal of hard and soft
material from flat surfaces such as
the removal of vinyl flooring, bonded
carpet adhesive, tile floor adhesive,
grout, paint and varnish.
Flexible scraper.
(Part number - STA26140-XJ)
Ideal for removal of elastomer
materials from hard flat surfaces in
difficult to reach areas such as silicon
sealant and other caulking materials.
Assembly
Fitting and removing the accessories (fig. G - H)
Warning! Before fitting an accessory, disconnect the tool from
the mains supply/Remove battery from tool.
Fitting a Stanley Fat Max accessory (fig. G - H)
Hold the tool and squeeze the accessory clamping lever
u
(4).
Slide the accessory (13) between the shaft and the acces-
u
sory holder making sure the accessory engages all eight
pins on the holder and is flush with the shaft.
Release the accessory clamping lever.
u
Note: Some accessories, such as scrapers and blades can be
mounted at an angle if required..
Removing a Stanley Fat Max accessory accessory
Hold the tool and squeeze the accessory clamping lever
u
(4).
Pull the accessory from the tool making sure the acces-
u
sory dis-engages from all eight pins on the holder.
Release the accessory clamping lever.
u
Warning: Gloves must be worn when removing accessories
as then may become hot during use.
Fitting a sanding sheet (fig. J)
Line up the sanding sheet with the sanding base as
u
shown.
Carbide grout removal blade.
(Part number - STA26125-XJ)
Carbide coated surface ideal for
clearing grout and tile adhesive from
flat surfaces and for fast stock
removal of wood, chipboard and
fibreglass.
Carbide rasp.
(Part number - STA26130-XJ)
Carbide coated surface ideal for grout
removal and for fast stock removal of
plastics, chipboard and fibreglass.
Sanding Sheets.
(Part number - STA32348-XJ)
Various grades for sanding of wood,
painted and varnished surfaces.