Troubleshooting - Utilitech CYWE08-7 Manual Del Usuario

TROUBLESHOOTING

PROBLEM
The Heater will
not power on
Power light is on,
but no heat is
emitting from the
unit.
The Heater is
creating a
burning smell
The heater is
making smell
cracking sound
POSSIBLE CAUSE
The thermal cut-off has
been activated.
Heater is not plugged
into a 120V polarized
outlet/receptacle.
Breaker/Fuse has been
tripped.
Room temperature has
warmed up to thermostat
setting.
The heating elements
inside the unit have not
warmed up yet.
Check & ensure there are
no combustible material
3' (0.9m)Surrounding
.
the heater
The heater feet have not
been properly installed
on the unit.
It is normal for the heater
to emit small crackling
sounds as it heats
the oil inside the fins.
6
CORRECTIVE ACTIONS
Unplug and turn the heater off; allow
it to cool for 30 minutes. Once the
heater has cooled off, check to make
sure that there is no objects on or
adjacent to the unit. To resume
operation, plug the unit back in.
.
Ensure unit is OFF position. Plug in
unit and attempt to turn on again.
Check your electrical box to confirm
the breaker has not been blown. This
may occur if the receptacle is shared
between other High consumption
appliances.
Ensure unit is in the OFF position.
Plug in unit and attempt to turn on
again.
Attempt to plug unit into another
receptacle in the house.
To increase the room temperature,
adjust the thermostat control knob
to a higher setting by turning
clockwise.
Allow 20 minutes after the unit
has been turned on for the oil
fins to heat.
Remove the combustible units
adjacent to the heater.
Follow assembly instructions on
how to attach front and hind
.
legs to the unit
Allow heater to operate for
a period of time.
After the heater has warmed up,
the crackling sounds should
stop. Do not be alarmed. It will
go away after approximately
15 minutes.