Operating Instructions; Thermostat Control; Care And Maintenance - Utilitech CYWE08-7 Manual Del Usuario

OPERATING INSTRUCTIONS

WARNING: Do not operate the product until fully assembled (including castors )
WARNING: Operate the product in an upright position only.
1. Place the product upright on a flat, level, stable,heat-resistant surface, and then uncoil the power
cord, removing it completely from the cord storage spool.
The power indicator will illuminate after being plugged in.
2. Turn the thermostat control knob clockwise to its maximum range.
3. Main Control Knob (Figure 1): Use this knob to set the heat setting:
"Ⅰ" – Low heat setting (600 watts)
"Ⅱ" – Medium heat setting (900 watts)
"Ⅲ" – High heat setting (1500 watts)
4. When the desired ambient temperature is reached, slowly turn the thermostat knob back
toward MIN until it clicks. The product will cycle on and off to maintain that setting.
NOTE: The product may emit an odor during first use; this is normal. Ventilate the area as needed.
5. Turn off the product by rotating the Main Control Knob
P P P P O O O O W W W W E E E E R R R R
Ⅲ
Ⅱ
Ⅰ
0
Figure 1

CARE AND MAINTENANCE

Always unplug the heater before cleaning and allow the heater to cool down.
1. Clean the unit with a soft cloth moistened with a mild soap and water solution.
2. Never use abrasive or flammable solvents to clean the unit.
3. After cleaning, be sure to completely dry the unit with a cloth or towel.
4. Store heater unit with cord in a cool, dry location. We recommend storing the unit and
cord in the original package.
A.
E
F
B.
E. Power light
G F. Selector
C.
G. Thermostat Control
5