Optiox™ Bod Adapter And Protective Guard; Fitting The Wrist Strap; Sevengo™ Clip - Mettler Toledo SevenGo pro Instrucciones De Montaje

Connecting an ISM® sensor
®
ISM sensor
When connecting an ISM
calibration data to be transferred automatically from the chip of the sensor into the meter and is used for further
measurements. After attaching the ISM
the meter must be switched on.
If the meter is already switched on, the READ key is pressed.
If the meter is already switched on, the CAL key is pressed.
We strongly recommend you to switch off the meter when disconnecting an ISM sensor. In doing so, you make
sure that the sensor is not removed while the instrument is reading data from or writing data to the ISM-chip of
the sensor.
The ISM icon
display.
3.3 OptiOx™ BOD adapter and protective guard
Installing the BOD adapter or the protective guard
Unscrew and remove the thread ring from the InLab
Slide the BOD adapter or the protective guard over the front of the InLab
sensor.

3.4 Fitting the wrist strap

3.5 SevenGo™ clip
The SevenGo™ clip is an electrode holder that can be placed next to the display on either side of the housing.
Note
SevenGo (Duo) pro™/OptiOx™
®
sensor to the meter, one of the following conditions have to be met for the
®
sensor,
appears on the display and the sensor ID of the sensor chip is registered and appears on the
The special BOD (biochemical oxygen demand) adapter enables quick and
easy measurement in all current types of BOD bottles with the InLab
OptiOx.
Thanks to the adapter the sensor reaches into the bottle only as far as
needed so that less water is being displaced during measurement.
According to the EPA (Environmental Protection Agency, USA), stirring is not
necessary thanks to RDO technology.
The robust protective guarde made of stainless steel provides optimum
protection even in harsh environments.
Thanks to the additional weight of the protective guard it also acts as a
sinker taking the InLab
Fit the wrist strap as shown in the diagram.
®
OptiOx to deeper measurement locations.
®
OptiOx. Keep it for later use.
®
OptiOx and screw it onto the
®
Installation​ ​ 7