Sanus VisionMount VLMF109 Manual Del Usuario página 21

Wall Mounting
For assistance in determining wall plate location, see Height Finder at sanus.com.
Mount the wall plate near an outlet. Be sure the mount will not obstruct the outlet.
NOTE: TV shifts 7 in. (17.8 cm) from the home position to full extension.
2-1: Wood Stud Mounting
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:
Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.), using a 5.5 mm (7/32 in.) diameter drill bit.
Ù
DO NOT over-tighten the lag bolts [26].
Ù
Any material covering the wall must not exceed 16 mm (5/8 in.).
Ù
Minimum wood stud size: common 2 x 4 in (nominal 1.5 x 3.5 in)
Ù
2-2: Solid concrete and Concrete Block Mounting
CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:
Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.), using a 10 mm (3/8 in.) diameter drill bit.
Ù
Be sure the anchors [27] seat flush with the concrete surface.
Ù
Mount wall plate directly onto the concrete surface.
Ù
Never drill into the mortar between blocks.
Ù
DO NOT over-tighten the lag bolts [26].
Ù
Minimum solid concrete thickness: 8 in.
Ù
Minimum concrete block size: 8 x 8x 16 in.
Ù
Wood Stud Wall Mounting – See Cautions in Step 2.
1. Locate studs. Verify the center of the stud with an awl or thin nail or use an edge to
edge stud finder.
Level the wall plate [02] and mark the hole locations.
2.
3. Drill pilot holes as illustrated.
Tighten the lag bolts [26] only until the washers [25] are pulled firmly against the
4.
wall plate [02].
2
4
[25]
[26]
(6901-002113 <01>)
CAUTION:
[02]
[02]
13 mm
(1/2 in.)
1
< 16 mm
(5/8 in.)
3
89 mm
3.5 in.
002534.eps
LF288 / XF288 - Mount to wood stud
2
5.5mm
(7/32 in.)
2-1
41 - 61 cm
(16 - 24 in.)
21