Maintenance And Care; Disposal Information - Flex SMS 190 18.0-EC Manual De Instrucciones

SMS 190 18.0-EC
d Tilt the saw head to desired angle,
tighten the bevel-lock knob.
e Attach the battery pack to the saw.
f Grasp the main handle and turn on the
on/off switch. Always allow the blade to
reach full speed before cutting.
g Lower the saw arm all the way down, and
cut through the work piece.
h Release the On/Off switch. Wait until the
blade comes to a complete stop before
returning the saw arm to the raised
position, then remove the work piece.
Cutting grooves (see figure W1 ,W2)
a Remove the battery pack from the saw
b See the related section :Setting Cutting-
Depth to set the desired depth of cut
c Space the work piece away from the
fence with a wooden spacer. This will
allow for a complete groove to be cut. Be
sure the work piece is fully supported.
d Attach the battery pack to the saw.
e Cut the two outside edges of the groove.
f To create the groove, use a wood chisel or
make multiple passes with a router to remove
the material between the outside edges.
Transporting
WARNING!
Remove the battery pack from the saw before
transporting mitre saw to avoid possible injury.
Preparing to lift the saw
– Set the bevel angle at 0° and lock it in place,
using the bevel-lock knob.
– Turn the mitre table to either 45° right or 45°
left and lock it in place with the mitre-control
lever.
– Set the saw head to the closest position in
relation to the fence.
– Lock the head assembly in the transport
position with the arm-lock pin.
Lift the saw by the carrying handle
(see figure X1)
Grip the saw by the carrying handle. Continue
to lift and transport comfortably.
Lift the sa w by the side carry
han dles (see figure X2)
Use upright, good posture and grip the two
handle areas beneath the base.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
■ Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
■ Regularly blow out the housing inferior
and motor with dry compressed air.
■ For safe and proper operation, always
keep the tool and its ventilation slots clean.
■ Always wear safety goggles or safety
glasses with side shields when blowing
dust. If operation is dusty, also wear a dust
mask.
■ Always use only a soft, dry cloth to clean
your mitre saw; never use detergent or
alcohol.
Gears
NOTE
Do not loosen the screws on the gear head
during the warranty period. Non-compliance
will deem the guarantee obligations of the
manufacturer null and void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
For other accessories, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusabte:
mains operated power tool by removing
the power cord,
35