Flex SMS 190 18.0-EC Manual De Instrucciones página 29

SMS 190 18.0-EC
18 Mitre Detents
19 Mitre-scale Indicator
20 Insert Plate
21 Mitre-control Lever
22 Laser Len
23 Dust-extraction Port
24 Carrying Handle
25 Spindle-lock Pin
26 Fence-lock Knob(left and right)
27 Work-clamp Mounting Hole(left and
right)
28 Work-clamp Lock Knob(left and right)
29 Rubber Foot(4)
30 Mounting Holes(4)
31 Double-ended Allen Wrench
32 45° Bevel Stop
33 Bevel-stop Bolt
34 Bevel-lock Knob
35 Sliding-lock Knob
36 Arm-lock Pin
37 Dust Bag
38 Battery
Assembly
WARNING!
Avoid unintentional starting of the machine,
during assembly on the machine, always
remove the battery pack from the saw.
Unpacking and checking
contents
WARNING!
If any parts are missing, do not turn the switch
on until the missing parts are obtained and
are installed correctly
Unpack the mitre saw and check if all parts
listed below:
– Mitre Saw
– Work Clamp
– Dust Bag
– Double-ended Allen Wrench
– Carrying Handle
– Long screw
– Short screws(2)
Tools Needed(not supplied)
Combination square
T25 Torx wrench
Mounting on a level and stable
surface
WARNING!
To ensure safe handling, the machine must be
mounted on a level and stable surface (e. g.,
workbench) prior to using.
Mounting to a Working Surface
(see figures B1–B2)
– Fasten the mitre saw to the working surface
by using suitable fasteners. The mounting
holes 30 serve for this purpose.
or
– Secure the mitre saw to the working surface
by using two commercially available clamps
or more.
Mounting to a FLEX Saw Stand
This mitre saw can be mounted on FLEX
WB 110-260 saw stand, referring to the
instruction of saw stand for its installation.
WARNING!
Read all safety warnings and instructions Read all safety warnings and instructions
included with the saw stand. Failure of included with the saw stand.
observing safety warnings and instructions
can cause serious injuries.
WARNING!
Assemble the stand properly before mounting Assemble the stand properly before mounting
the power tool. the power tool. Perfect assembly is important
in order to prevent the risk of collapsing.
Mounting the Carrying Handle
(see figure C)
Align the carrying handle with its mounting
area on the saw. Secure the carrying handle
in place by using a long screw and two short
screws. The small end of the supplied double-
ended allen wrench is used for this purpose.
2.5mm wrench
5mm wrench
29