Use And Maintanance; Before Use; Operating Instructions; Packing Operations - Active TIGERCUT 35 Manual Del Usuario

Use and maintenance
Instructions before use:
1. Please con rm the power of the battery pack before use.
2. When the trimmers are not in use, make sure that the trimmers and the power supply
are disconnected. Please bear in mind that the power supply of the trimmers must be
disconnected in the process of refueling, grinding blade and replacing blade.
3. Please check the tightness of the blade before use (see P11).

Operating instructions

1. Open the package and insert the battery pack into the insertion interface of the
electric trimmer.
2. Turn on the power control switch, and the power indicator is green. (see P3)
3.When the power is on for the rst time, the buzzer rings twice, and the trigger is pulled
twice continuously to enter the activation state.
4. Normal shearing: press the trigger and the blade closes. Release the trigger and the
blades open. Blade closing: press the trigger continuously, and the long sound of buzzer
is the blade closing state.
5. Before working, please press the trigger intermittently to close the blade without load
for several times to check whether it is normal.
6. Start working after normal operation.
7. In the event that the branches are small in diameter and you want to speed up the cut,
set the opening of the blades at 25 mm instead of 35 mm. For this setting, proceed as
follows: after turning on the machine, press and hold the trigger for 2 seconds, until an
acoustic signal is emitted. To restore the previous setting, repeat the operation.
Pruner
ON/OFF
button

Packing operations

1. Press and hold the trigger for more than 5 seconds, release the trigger, the blade will
close and no longer open.
2. Turn o the power and remove the battery.
3. Sorting, cleaning and packing.
Battery
ON/OFF
button
27