Setting The Transmission Mode For An Rs-485 Interface - Sony SVT-RS100 Manual De Instrucciones

5
Press MENU V on the VCR.
"RS-485" and "RS-232C" appear in the display on
the VCR. Select "RS-232C" by pressing MENU +
or –.
6
Press MENU V on the VCR.
Set the transmission speed (baud rate) to 19200,
9600, 4800 or 2400 bps by pressing MENU + or –.
Example: The display shows that the transmission
speed is set to 19200 bps.
7
Press COUNTER RESET button on the VCR.
The setting you made will be executed and the
display will return to the normal display.
Setting the transmission mode
for an RS-485 Interface
1
Install the SVT-RS100 into the VCR following the
procedures on page 4.
2
Press POWER (or ON) button on the VCR to turn
on the power.
3
Press the COUNTER RESET button on the VCR
for 3 seconds or more to enter the transmission
setting mode.
Note
Make sure that no cassette is in the VCR.
4
Press MENU V on the VCR to set the transmission
mode.
Each time you press MENU V, the mode changes
as follows: selecting RS-485 or RS-232C
connector to be used, setting the address (only
when using the RS-485 connector) and setting the
transmission speed (baud rate).
5
Press MENU V on the VCR.
"RS-485" and "RS-232C" appear in the display on
the VCR. Select "RS-485" by pressing MENU +
or –.
6
Press MENU V on the VCR.
Set the address between 0 and 127 by pressing
MENU + or –.
Example: The display shows that the address is set
to 124.
7
Press MENU V on the VCR.
Set the transmission speed (baud rate) to 19200,
9600, 4800 or 2400 bps by pressing MENU + or –.
Example: The display shows that the transmission
speed is set to 19200 bps.
8
Press COUNTER RESET button on the VCR.
The setting you made will be executed and the
display will return to the normal display.
7