Graymills HANDI-KLEEN PL364FB Instrucciones De Operacion Y Mantenimiento página 7

The work area should be well ventilated.
Provide adequate lighting in the work area to allow observation of the cleaning process and the floor
area around the machine. Be sure to allow adequate room to bring work to and from the machine.
Provide sufficient clearance around the machine for fluid changeovers and servicing.
Site Preparation
Before installing, careful consideration should be given to the place of operation. Place unit on a
smooth, level surface. To the extent possible avoid installing machine in areas subject to high forklift
traffic. Reasonable precautions shall be taken to avoid damaging the legs and tank walls.
Assembly
After removing the Handi-Kleen from its shipping carton remove any shelves or loose internal parts
from the tank (FIGURE 1(A)) and place tank on its side and assemble legs (FIGURE 1(B)) on the
outside of tank brackets (if placed on inside of brackets, holes will not align). It is recommended that the
flattened shipping carton be placed under the tank while assembling the legs to avoid scratching the
paint and that a minimum of two assemblers be employed for this task. Securely tighten all 16 screws
(FIGURE 1(C)) into the weldnuts on the tank making sure to include all flat washers (FIGURE 1(D)).
Turn unit upright. Install the Handi·Kleen in a convenient location close to an electrical outlet, away
from open flame or sparks. Check and tighten all fittings before filling with solvent. Liquid level should
remain under the high-level line. Do NOT overfill. Keep cover closed when not in use to reduce
evaporation of cleaning fluid. The reflective white cover aids visibility when open.
795-93848
INSTALLATION AND OPERATION
FIGURE 1
7 of 41
COMPONENT
REFERENCE
A Tank Assembly
B EXTENSION LEG,16 GA.
C M/S RD HD 10-32NF X 1/2 316
D FLAT WASHER NO.10,1/2OD,.200ID
DESCRIPTION
12/23/21
QTY.
1
4
16
12