Rear Panel - FONESTAR PROX-15 Manual De Usuario

1 2
CLIP
13.- : signal peak indicator light for each input. If it lights up slightly or occasionally, you should reduce
the output volume. If the indicator light remains on continuously, it is because the input signal has a very
high level. In this case, reduce the volume of the input signal.
14.- SIGNAL: signal status indicator light. It lights up when a signal is detected at the inputs

REAR PANEL

7
1.- MIC - VOX: sensitivity to give priority to the MIC signal over the rest of the signals. Depending on this
setting, the signal level required at the MIC input to cut the audio from the rest of the sources will be
higher or lower.
2.- MIC - GAIN: gain of the MIC input.
3.- BASS: attenuates/reinforces the bass frequencies.
4.- TREBLE: attenuates/reinforces the high frequencies.
5.- FM ANT: input for the connection of an FM antenna.
6.- AC SELECT: power supply voltage selector.
7.- AUX: stereo auxiliary input for the connection of audio devices such as mixing consoles, computers,
etc. This input has 2 connector options, 2 x RCA or euroblock.
8.- MIC: microphone input. This input has 2 connector options, unbalanced 6.3 mm jack or balanced
euroblock.
9.- EMERGENCY INPUT: 100 V audio input to connect an emergency system, euroblock.
10.- REMOTE MUTE: remotely mute/unmute the speaker output with the help of a switch, euroblock
connector. This input is in open circuit, to mute it you will have to close the circuit.
11.- SPEAKER OUTPUT: low impedance speaker output and 100 V line, euroblock connector. Please note
that the choice of speakers must be in accordance with the specifications of the amplifier and the type
of output chosen (high or low impedance).
12.- 12 V DC, 15 W: input for the power supply of the amplifier via 12 V DC input.
13.- Power supply input of the amplifier 115/230 V.
3 4 5 6 7
1 2 3
R GAIN
BASS
L VOX
8 9
8 9 10
4 5
TREBLE
10 11
- 3 -
11 12 13
6
POWER CONSUMPTION: 50 W
+ –
230 V AC, 50/60 Hz FUSE: T1 A
115 V AC, 50/60 Hz FUSE: T1 A
12 13
14
EN