Unpacking; Before Commissioning; Changing Sanding Sheets - Scheppach CGP1200 Traducción Del Manual De Instrucciones Original

Noise and vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB (A), please
wear suitable hearing protection.
Note: The vibration level specified in these instructions
has been measured based on a standardised measure-
ment procedure and can be used for unit comparison.
The specified vibration emission value can also be
used for an initial estimation of the exposure.
m Warning!
The vibration level will vary depending on the use of the
electric tool and may in some cases be higher than the
value specified in these instructions.
The vibration load could be underestimated if the elec-
tric tool is regularly used in such a way. Try to minimise
stress from vibrations as low as possible. Some ex-
amples of means for reducing the vibration stress are
wearing gloves while using the tool and limiting work
time.
In doing so, all parts of the operating cycle must be
taken into account (such as times in which the electric
tool is switched off or times in which it is switched on,
but is not running under a load).

10. Unpacking

• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating instructions before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
30 | GB
m WARNING!
The device and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!

11. Before commissioning

Warning!
Unplug the mains plug from the socket before carrying
out any work on the device!
Caution!
Wear protective gloves when changing tools. There is a
danger of injury if the insert tools are touched.
Depending on the material to be machined and the de-
sired removal of the surface, different insert tools are
available.
Note: Do not put the device down without the insert
tool (grinding wheel, carbide cup wheel, etc.) mounted.
The brush rim (5) may bend and be damaged.

11.1 Changing sanding sheets

The surface of the grinding wheel (13) is made of a Vel-
cro fabric so that you can attach sanding sheets (16)
with Velcro quickly and easily.
• Before fitting a new sanding sheet (16), remove dirt
and dust from the grinding wheel (13), e.g. with a
brush.
• Place the sanding sheet (16) flush against the edge
of the grinding wheel (13). Then place the sanding
sheet on the grinding wheel (13) and press it firm-
ly. Make sure that the suction holes on the sanding
sheet (16) and grinding wheel (13) match.
• To remove the sanding sheet (16), lift it sideways and
pull it off the grinding wheel (13).
11.2 Fitting/replacing the insert tool (Fig. 2, 4)
m WARNING! Only operate the spindle locking button
(7) when the grinding spindle (12) is stationary. Other-
wise the device may be damaged.
• Only use carbide cup wheels (10) with a flat grinding
surface.
• Clean the grinding spindle (12) and all parts to be
mounted.
• To clamp and release the insert tool, press the spin-
dle lock button (7) to lock it.
• To attach the insert tool, place the mounting flange
(11) on the grinding spindle (12).
www.scheppach.com