Operation; Adjust The Cutting Height; Adjust The Mower Blade; Check The Adjustment - GreenWorks 25072 Manual Del Operador

EN
2. Place the hooks on the rear bag onto the roller shaft.
Secure the bag to the lower handle with the belt.
3. Adjust strap for proper height so the bag does not rub the
ground while mowing or transporting.
10

OPERATION

Align cutting path indication arrow with previously cut path.
The width of the machine actual cut is indicated below. Do
not use wheels as a reference point for grass cut line.
10.1

ADJUST THE CUTTING HEIGHT

The machine can be set to different cutting heights.
NOTE
20''
English
13
1. Move the height adjustment levers (13) on both sides to a
higher position to increase the cutting height.
2. Move the height adjustment levers on both sides to a
lower position to decrease the cutting height.
The two adjustment levers must be set to the same position.
10.2

ADJUST THE MOWER BLADE

Blades are extremely sharp. To avoid injury, do not touch
blades when making adjustments.
1. The misalignment of blades can cause an uneven cut or
difficulty pushing the mower.
2. Each end of the cutting bar is adjusted separately.
3. Turn the adjustment screw clockwise to move the cutting
bar closer to the blades.
4. Turn the adjustment screw counterclockwise to move the
cutting bar away from the blades.
5. When the space equals the thickness of paper (0.12 mm),
insert a piece of paper between the blades and the cutter
bar, and quickly turn the wheel by hand.
It is a sensitive procedure to adjust the screws for blade
adjustments. A sixteenth of a turn is a major adjustment.
Βefore tightening one adjustment screw, loosen the opposite
screw an equal amount.
10.3

CHECK THE ADJUSTMENT

1. Turn the machine upside down.
6
NOTE
WARNING
Adjustment screw
CAUTION