Proposition 65; Unpack The Machine; Install The Handle; Attach The Handle To The Mower Base - GreenWorks 25072 Manual Del Operador

5

PROPOSITION 65

WARNING
This product contains a chemical known to the state of
California to cause cancer, birth defects or other
reproductive harm. Some dust created by power sanding,
sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals
are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other
masonry products;
• Arsenic and chromium from chemically treated lumber.
Your risk of exposure to these chemicals varies depending
on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area,
and work with approved safety equipment, such as dust
masks that are specially designed to filter out microscopic
particles.
Save these instructions.
6

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
7

INSTALL THE HANDLE

Do not completely tighten knobs until assembly is
complete.
NOTE
English
2
3
1. Lay handles flat on ground.
2. Insert the middle handles (2) into the left and right side of
the upper handles (1), and secure with the carriage bolts
(7) and knobs (8).
3. Insert the lower handles (3) into the left and right side of
the middle handles (2), and secure with the carriage bolts
(9) and knobs (10).
4. Tighten all the knobs on the joints of the handle assembly.
8 ATTACH THE HANDLE TO
THE MOWER BASE
11
1. Align holes (11) at the lower end of each handle arm with
posts (12) extending from the mower base side plates.
2. Slide lower ends of handle arms onto posts.
9

INSTALL THE REAR BAG

1. Take out all components in the packing.
5
1
8
7
10
9
12
EN