Start; Switching On/Turning Off; Operating Modes - Vitrifrigo STR6000 Manual De Uso

6 START

Once installation has been completed, check the continuity of the earth circuit and carry out all the electrical
safety tests provided for by current regulations. Protect and adequately block the cables to avoid any risk of
accidentally pulling the cable which could disconnect it or which could cause it to come into contact with a
hot part of this appliance (or another one) at a temperature over 50°C or with a sharp part. If the power cable
is damaged, it must be replaced by the manufacturer or by the manufacturer's technical service centre or, in
any case, by a person similarly qualified, in such a way as to prevent any risk.
• Make sure that all the packaging materials have been removed.
Test all piping to make sure that there are no leaks.
•
Check all the electrical connections.
•
Motor protection time. The appliance is equipped with a motor protection control which starts the compressor
only after 1 minutes from the last power on. This also happens after any interruption in the electrical supply,
whether voluntary or involuntary (a blackout).
5.1

Switching on/Turning off

To turn the air conditioner on/off, press and hold the ON/OFF key for 2 seconds.
5.2

Operating modes

The unit is able to operate in 3 distinct modes by selecting them from the control panel with the E key. To set
the various modes, press the MODE (E) key and refer to the following table:
The system works autonomously, adjusting the speed of the compressor and fans
to ensure maximum performance.
AUTO
Press the MODE key repeatedly until the symbol
The system works autonomously, adjusting the parameters in order to ensure
maximum duration of operation. The electronic board regulates the fan and
ECO
compressor speeds to minimise consumption and to increase autonomy.
Press the MODE key repeatedly until the symbol
The system works autonomously, adjusting the parameters in order to ensure
maximum operating silence. The electronic board regulates the speed of the fans
NIGHT
and the compressor to minimise noise inside the cab.
Press the MODE key repeatedly until the symbol
In all the listed modes the fan speed is automatic, however it is possible to change the speed at any
time according to your needs by pressing the D key.
32
appears
appears
appears