Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATION
Connect the power cable to a power socket that is located in a safe, dry area.
-The switch on the heater head is used to control the two-heat setting.
(I) for 1500W -(II) for 3000W.
-Although the heater is shower proof, do not use when raining or in wet conditions.
- Always disconnect the power cable from the electrical supply, when the heater is not in use.
CLEANING AND MAINTENANCE
-
When disconnected from the power supply, clean the outside of the patio heater with a
damp cloth. Never use corrosive or solvent cleaners or immerse in water.
-
Any maintenance or repairs, including replacing the lamp tube should only be carried out
by the Technical Assistance or a qualified electrician.
Only use the heater on a firm solid horizontal surface where all the feet on the base are in
contact with the floor. (Should the heater be tilted or fall over the auto security system, cut off
switch, will activate)
1. Position the heater outside or in a large open area and well away from any obstructions
such as branches or where the heater is near any objects that can be affected by heat,
such as furniture, curtains or other inflammable objects (minimum distance 1 meter).
2. Do not use in non-ventilated areas.
3. Do not push any items through, obstruct or cover the grill of the heater head.
4. Do not move when connected to a power supply and always wait for the heater to cool
down before storing away.
5. The head of the unit is at high temperature during operation. Do not touch the heater head
when in use. Unplug the unit and wait till it cools before cleaning
6. Do not leave turned on and unattended especially when children and or animals are in the
vicinity.
7. The indication of the different positions of switches shall be visible from a distance of 1.5m.
8. The rating label or other marks shall be visible after the heater has been installed. It shall
not be placed at the back side of heaters.
9. The unit must be fixed with the clearance of 100cm to the wall and 30cm to the ceiling.
10. The unit must be correctly installed according to the instructions. Make sure the head is
at least 1.8m from the floor.
11. The unit is at high temperature during operation. It keeps hot for a period after shut down.
Potential danger would occur when touching it during this period.
12. Don't cover the unit with anything during operation or a short time after it's shut down.
Don't wrap the power cable around the unit.
13. The unit must be handled with care, and avoid vibration or hitting.
23
Tabla de contenido
