Using The Oral Irrigator - Nevadent SMD 24 A1 Instrucciones De Uso E Indicaciones De Seguridad

Using the oral irrigator

CAUTION – PROPERTY DAMAGE!
► Fill the water tank
wash. The water tank
mouthwash or mouth rinse.
► Use only cold or lukewarm water with a maximum temperature of 40°C. Do not fill
the water tank
NOTE
► Use of the appliance is not a replacement for daily tooth cleaning with a toothbrush
and toothpaste. Use the appliance only as a supplement to daily tooth cleaning with
toothbrush and toothpaste.
► Only use the appliance for a maximum of 2 minutes or only long enough to use
up one full tank of water (600 ml). One full tank of water (600 ml) is sufficient to
operate the appliance for about 150 seconds at level 1 or about 110 seconds at
level 5.
► The unfamiliar stimulation may cause some gum bleeding at first, which is not
unusual. If this continues for more than two weeks, you should consult your dentist.
► Consult your dentist before using the appliance if you suffer from severe periodontitis,
have injuries or abscesses in the mucous membrane of the oral cavity or underwent
dental surgery within the last two months.
♦ Remove the water tank
e
tank . Fill the water tank
e
water tank
again with the lid
♦ Fit a nozzle attachment
into the opening until the nozzle attachment
Ensure that the guide tab on the lower end of the nozzle attachment
the corresponding groove in the opening on the hand unit
♦ Switch on the main unit
level 1‒5 (1 = gentle, 5 = strong).
♦ Open your mouth slightly and insert the nozzle attachment
to allow the water to run into the basin.
│ GB │ IE
■ 10
e
with pure tap water. If necessary, add a few drops of mouth-
e
should never be completely filled with additives such as
e
with hot water.
e
from the main unit
e
with cold or lukewarm water. Take care not to fill the
past the maximum fill mark of 600 ml. Then close the water tank
t
and place the water tank
2
onto the hand unit
w
by setting the rotary switch
w
and open the lid
e
in the main unit
4
. Press the nozzle attachment
2
audibly engages in the hand unit
4
.
r
to the desired water pressure
2
. Bend over a washbasin
t
of the water
e
w.
2
4
.
2
is aligned with
SMD 24 A1