Handling And Operation; Attaching/Removing Nozzle Attachments - Nevadent SMD 24 A1 Instrucciones De Uso E Indicaciones De Seguridad

4. Push the appliance onto the screws
on the back side of the appliance. Then press the appliance downward so that the
8
screws slide into the rails of the hangers
8
screws .
5. Slide the locking pin
6. Plug the mains plug of the power cable

Handling and operation

Attaching/removing nozzle attachments

NOTE
► If used daily, replace the nozzle attachments
► Use only original nozzle attachments
nozzle attachments
♦ Make certain that the appliance is switched off before attaching or removing the
nozzle attachment
♦ Fit a nozzle attachment
into the opening until the nozzle attachment
Ensure that the guide tab on the lower end of the nozzle attachment
with the corresponding groove in the opening on the hand unit
♦ To remove the nozzle attachment
and then pull the nozzle attachment
Fig. 2
│ GB │ IE
■ 8
8
so that the screws
7
upwards until it audibly engages with the hanger
q
2
2
can be found in the section Ordering replacement parts.
2
.
2
onto the hand unit
2
, press the release button
2
Click
Fig. 3
8
enter into the hangers
6
and the appliance rests firmly on the
into a socket.
2
after no more than six months.
. Information on ordering replacement
4
. Press the nozzle attachment
2
audibly engages in the hand unit
4
out of the hand unit
2.
1.
6
6
.
2
4
2
is aligned
4
(see Fig. 2).
0 4
on the hand unit
(see Fig. 3).
SMD 24 A1
.