Product Characteristics; Technical Data - YATO YT-82560 Manual Original

PRODUCT CHARACTERISTICS

The painting unit is an electrical device used to cover the surface with a coating material or varnish. The unit does not need to
be supplied from an external source of compressed air, the coating material is applied from the unit to the gun by means of a
fl exible hose. The long hose connecting the gun to the unit allows the universal use of the product. The unit has been equipped
with a pump that sucks the paint from any tank. Correct, reliable, and safe operation of the device is dependent on its proper use,
therefore:
Before working with the tool, read all instructions and keep for further reference.
For any damage or injuries caused by the tool misuse, failure to comply with safety regulations and instructions in this manual,
the supplier will not be responsible.
EQUIPMENT
The package should contain: painting unit, spray gun, hose connecting the gun with the unit.

TECHNICAL DATA

Item
Catalogue number
Mains voltage
Network frequency
Rated power
Power consumption
Electrical protection class
Weight
Maximum operating pressure
Nominal capacity
Temperature of the coating material
Hose length gun - unit
Noise level
Pressure L
pA
Power L
wA
Vibration level a
h
Degree of protection
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters what-
soever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and
O R I G I N A L
GB
Measurement unit
[V~]
[Hz]
[W]
[A]
[kg]
[MPa]
[l/min]
[ C]
O
[m]
[dB(A)]
[dB(A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82560
220 - 240
50
650
2,0 – 4,5
I
6,5
20,7
1,1
5 ~ 40
7,5
93,3 ± 3,0
104,3 ± 3,0
≤ 2,5
IP20
15