Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Adjusting the horizontal gap between the shearing blades
Adjust the horizontal gap between the shearing blades (A in Fig. 2) at approximately
1/10 the steel plate thickness to be sheared, according to the following procedures.
(Fig. 3)
Moving Blade
(1) Loosen the hexagonal socket bolts fastening the stationary blade. Loosen the M4 lock
nut, and push back the M4 slotted set screws slightly.
(2) From the supplied thickness gauges, select one that is 1/10 the thickness of the panel to
be cut. Thickness of each thickness gauge is marked thereon. Insert the gauge in between
the blades, then tighten the hexagonal socket bolts very loosely. Next, use a screwdriver
to turn the M4 slotted set screws to position the stationary blade until it hits the thickness
gauge.
(3) If the space between blades is larger than the thickness of the panel to be cut, there will
be burrs for a less than clean cut.
If the space between blades is too narrow, cutting speed will be affected. For cutting in
a curved line, making the space a little bigger will make the cutting easier.
(4) After adjustment, tighten the M4 nuts securely so they will not loosen during operation.
(5) Securely tighten the hexagonal socket bolts fastening the stationary blade.
All manuals and user guides at all-guides.com
Stationary Blade
Thickness Gauge
Fig. 2
Stationary Blade
Hexagon Socket Hd. Bolt
Fig. 3
English
Lock Nut M4
Slotted Set Screw M4×14
11
Tabla de contenido
