Basic Operation; Turning On And Off The Tv; First Time Setup - Brandt B4302UHD LED Manual De Instrucciones

Basic Operation

Turning on and off the TV

Turn on the TV
Plug the power cord into a suitable power point, then press the POWER (
on the lower side of the back panel (or on the remote control, making sure to aim it at
the sensor at the front of the TV);
Turn off the TV
Press the button on the remote control to enter standby mode. To power down the
TV completely, unplugs the power cord from the mains socket.
Do not leave your set in standby mode for long periods of time. If you will not use the
TV for a long time, it is recommended to unplug the set from the mains and aerial.

First Time Setup

If this is the first time you run the TV, the Initial Setup Menu will appear in the picture,
and the items of this menu also exist in other menus, so you are able to change the
values after you set them up.
Tips: Make sure that the antenna or cable TV system connection is made.
Select you desired language
Press the / buttons to select the language to be used for menus and message
and then press the OK button to go to the next step.
Select your country
Press the / / /
the OK button to go to the next step.
Press the button to select "< Back" to go to previous step.
Select your time zone.
Press the / / /
go to the next step.
Press the button to select "< Back" to go to previous step.
Select the antenna type (Air, Cable and Satellite).
Press the / buttons to select the tuning modes and then press the OK button.
(For more detailed information, please refer to Channel menu
The TV starts Auto Tuning.
If you press the MENU ( ) button in TV searching, the Auto Tuning will skip to DTV
searching as the suggestive picture shows.
NOTE:
If the TV doesn't receive any channels, please check your aerial connection or the
country you selected, and then try an auto search again.
If the TV just receives some of the channels, it means the aerial's reception isn't good
enough and an antenna service is recommended.
buttons to select the country you are living in and then press
buttons to select a time zone and then press the OK button to
17
) button,
Auto Tuning).