General; Technical Specifications; Accessories And Consumables; Safety - Cebora CP-70C Manual De Instrucciones

Before using this welding torch, read carefully this manual.
This welding torch is made in accordance with IEC 60974-7 standard safety requirements. According to the
above standard requirements CEBORA SPA declares that this welding torch must be used solely with CEBORA
power sources. Spare parts and consumables are integral part to this welding torch, therefore CEBORA
considers the use of parts that are not CEBORA genuine parts as a tampering action and consequently,
in accordance with the spirit of this same standard CEBORA assumes no responsibility including those
provided for in the guarantee contract.
Any use which is not described has to be considered as NOT ALLOWED.
Starting up, operation and maintenance must be carried out by skilled personnel.
Accident prevention regulations in force should be respected.
1

GENERAL

This welding torch, designed for plasma arc cutting of electro-conducting materials (metals and alloys) uses air as
plasma gas and cooling agent.
The "PLASMA ARC" cutting is the result of the high temperature generated by a concentrated electric arc and
therefore highly hazardous situations may occur. It is essential to pay especially close attention to the chapter on
SAFETY PRECAUTIONS in the manual of the power source to which the welding torch is connected.
These welding torches should not be used under rain or snow or equivalent condition.
This manual must be stored carefully in a place familiar to the operator using the welding torch. It must be consulted
whenever doubts arise and be kept for the entire welding torch life-span; it will also be used for ordering replacement
parts.
2

TECHNICAL SPECIFICATIONS

Maximum cutting current I2 = 70 A
Duty cycle X = 60% with I2= 70 A
Working pressure with a 6 m = 5.5 bar (0.55 MPa) cable.
Working pressure with a 15 m = 6.0 bar (0.60 MPa) cable.
Total air capacity = 230 litres/minute.
3

ACCESSORIES AND CONSUMABLES

See fig.1 for CP 70C MAR and fig2 for CP70C DAR
4

SAFETY

This welding torch is equipped with an electric safety devise located on the welding torch body to avoid any dangerous
voltage when the nozzle, the electrode, the swirl ring or the nozzle holder are replaced. It is in accordance with IEC
60974-7 Standard which requires that when a live nozzle is vertically located on a flat surface it should not be
touched with the conventional test finger whose characteristics are specified in the standard.
11