Conducting A Test - TREND NETWORKS FIBERMASTER Guía De Referencia Rápida

Manual limits may be selected on the OTDR Limits page. The following two
pages of limits will be displayed to set limits/thresholds.
Note: The Limits and test thresholds will be displayed for review prior to
taking a test.

Conducting a Test

Take a trace by selecting the Test button on the OTDR Setup screen. Once
the Test button is selected, the Test Parameter screen below will be displayed.
This screen displays the limits/thresholds that have been selected for pass/fail
analysis and the parameters set for the trace.
If the settings are correct, select the check box to start the test. A scanning
status bar will be displayed, followed by a finding event message.
Once all settings have been
established, touch the check mark
at the bottom of the page.
Load Defaults sets the default lim-
it values that would be industry
standard for each measured item.
Depend On Us
EN
7