TREND NETWORKS FIBERMASTER Guía De Referencia Rápida página 14

Basic Single Cord PM/LS Operation
EN
Note: This step may be skipped as the power meter will set itself to the
appropriate wavelength, if it is being used with a compatible source.
Plug one end of a reference cord into the light source and the other end into the
power meter as shown below.
Reference Cord
Power Meter
Port
14
www.trend-networks.com
Touch the Source indicator to
show the light source wavelengths
available and select the desired
wavelength for the test. Allow the
light source 2-3 minutes to warm
up and stabilize.
Touch the Modulation indicator
to open the modulation options
and set the modulation to CW for
Touch the Power Meter indicator to
show the power meter wavelengths
available and select the appropriate
wavelength for the test.
Touch reference indicator in the
bottom right of the display and
select, Set Reference to zero out
continuous wave.
the reference cord.
Light Source
Port
240810 Rev 1.