Honeywell PROFESSIONAL HPA600 Serie Manual Del Propietário página 8

CONTROLS (Cont.)
When the "PREFILTER" light is illuminated, it is time to clean (vacuum or wash) the 2 Permanent Mesh
Pre-Filters. The Permanent Mesh Pre-Filters are located on each side of the air purifier at the air intake.
You will have to remove the
capture larger airborne particles, such as dust and pet hair/fur. The Permanent Mesh Pre-Filters should be
cleaned every 3 months.
These replacement/cleaning intervals are intended as guidelines only. Performance of any filter media is
dependent upon the concentration of contaminants going through the system. High concentrations of
contaminants such as dust, pet dander, and smoke will reduce the useful performance of the filters. To help
ensure stated product performance, use only Certified Honeywell Replacement Filters.
REPLACING THE 3-IN-1 HEPA FILTERS
Power OFF and unplug the air purifier. Remove and dispose of used filters. See installation instructions in FIRST
TIME USE section on page 3 . This Honeywell True HEPA Professional Series™ Air Purifier takes two 3-in-1 HEPA
Filters (Item no. HRF-Z2). The
NOTE: the 3-in-1 HEPA
CLEANING PERMANENT MESH PRE-FILTERS
The Permanent Mesh Pre-Filters trap and capture larger airborne particles
that enter the intake grilles. It is important to keep these clean to optimize
airflow into the purifier and trap the larger debris before it reaches the HEPA
Filters. These pre-filters can be periodically removed and shaken or
vacuumed clean. Alternatively, they can be rinsed by hand under warm water
to clean. Let the pre-filters air dry completely before inserting them back in to
the air purifier. The pre-filters should be cleaned every 3 months.
To access the Permanent Mesh Pre-Filters, you will need to remove the two
HEPA Filters. Power OFF and unplug the air purifier. The Permanent Mesh
Pre-Filters are located on each side of the air purifier at the air intake. Grasp
the plastic tab(s) for removal (see Fig. 4) and gently pull inward and out
of the unit clearing the metal retention tabs. To replace clean (and dry)
pre-filters, simply return them to the same location and set them in place by
securing them behind the metal retention tabs (see Fig. 5).
AFTER YOU HAVE REPLACED OR CLEANED THE FILTERS YOU WILL
NEED TO RESET THE ELECTRONIC FILTER CHECK.
TO RESET THE ELECTRONIC FILTER CHECK
After the HEPA filters have been replaced and/or the pre-filters cleaned and re-installed in the unit, plug the
unit into the power outlet and TAP the
indicator for 2-3 seconds. A chime will sound and the indicator light will flash for 3 seconds and then shut off
to show the timer has been reset. Repeat step if the other Check Filter Indicator is illuminated.
Filters to access the mesh pre-filters. The Permanent Mesh Pre-Filters help
Z
Filter Filter
Filter Replacement Pack includes 2 filters. This is a 1 year supply.
Z
Filter Filter
Filters are not washable. DO NOT immerse them in water.
Z
Filter Filter
icon. Press and hold the reset icon
8
Tabs
For
Removal
Fig. 4
Retention
Tabs
Retention
Tabs
Fig. 5
next to the illuminated filter