Makita AS001G Manual De Instrucciones página 23

5. Reassemble the dust cap onto the suction inlet,
aligning the two locking tabs on the dust cap with the
guide grooves on the housing. Then turn the dust cap
clockwise to secure it in place.
3
Fig.49
► 1. Dust cap 2. Locking tabs 3. Suction inlet 4. Guide
grooves
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the man-
ual, do not attempt to dismantle the machine. Instead, ask Makita Authorized Service Centers, always using Makita
replacement parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
The tool does not reach the maxi-
mum air volume.
Abnormal vibration:
stop the tool immediately!
Motor cannot stop:
Remove the battery immediately!
4
1
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
The drive system does not work
correctly.
Electric or electronic malfunction.
2
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using the tool to cool it down.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Ask your local authorized service center for repair.
Remove the battery and ask your local authorized
service center for repair.
23 ENGLISH