Makita AS001G Manual De Instrucciones página 16

NOTICE:
Do not pull the switch trigger hard
without releasing the trigger-lock button. This can
cause switch breakage.
Switch trigger
Air volume can be controlled by squeezing the switch
trigger. Air volume is grown by increasing pressure on
the switch trigger. Release the switch trigger to stop.
1
Fig.21
► 1. Switch trigger
Lock button
For continuous operation, push in the lock button while
pulling the switch trigger and then release the switch
trigger. To cancel the locked-on operation, pull the
switch trigger fully, then release it.
1
Fig.22
► 1. Switch trigger 2. Lock button
Adjusting air volume
Air volume can be changed in four modes, that is, 4
(Max), 3 (High), 2 (Medium) and 1 (Low), depending on
the application and workload.
Press the air volume adjustment button to switch mode
in the following sequence. The mode changes every
time you press the button.
Fig.23
► 1. Low air volume 2. Medium air volume 3. High air
volume 4. Max air volume 5. Air volume adjustment
button
Air volume settings table
Air volume mode
4: Max
2
3: High
2: Medium
1: Low
*
NOTE: The tool is set in high air volume mode by
default.
NOTE: Air volume mode can be changed before
turning the tool on.
NOTE: The tool starts operation with the last air
volume mode settings in use.
16 ENGLISH
5
Maximum air volumes are measured without
nozzles.
1
2
3
4
Maximum air volume
3
1.1 m /min (39 cu.ft/min)
3
1.0 m /min (35 cu.ft/min)
3
0.8 m /min (28 cu.ft/min)
3
0.6 m /min (21 cu.ft/min)