Serial Number: ___________________________________
General Information
For most applications, this manual contains the information
necessary for the correct installation, operation, and
maintenance of the equipment. All efforts have been made to
make sure that the information in this manual is accurate and
current. We reserve the right to change the product and this
document without notification.
Equipment Description
•
Emergency generator systems are intended to
automatically supply illumination, power, or both, to
designated areas and equipment in the event of failure
of the normal supply. Emergency systems can also
provide power for such functions as ventilation where
essential to maintain life, where current interruption of
the normal supply would produce serious life safety or
health hazards.
•
Legally Required standby generator systems are
intended to automatically supply power to selected
loads in the event of failure of the normal source which
can create hazards or prevent rescue or fire-fighting
operations.
Installer Responsibilities
•
Read and obey the safety instructions.
•
Install only a NRTL-approved transfer switch that is
compatible with the generator.
•
Read and obey the instructions in this Installation and
Operation Manual.
•
Installation must strictly comply with all applicable
codes, industry standards, laws, and regulations.
•
Allow sufficient room on all sides of the generator for
maintenance and service.
•
Discuss the generator placement with owner.
•
Make sure that ALL manuals are given to the owner
after the installation has been completed.
Owner Responsibilities
•
Read and obey the instructions in this Installation and
Operation Manual.
•
Follow a regular schedule for maintaining and using the
generator, as specified in this manual.
•
Carbon monoxide detector(s) MUST be installed and
maintained indoors according to the manufacturer's
instructions and recommendations. Smoke alarms
cannot detect carbon monoxide gas.
•
Smoke detector(s) MUST be installed and maintained
indoors according to the manufacturer's instructions and
recommendations. Carbon monoxide alarms cannot
detect smoke.
Delivery Inspection
Avoid damage from dropping, bumping, or collision with the
shipping carton.
After removing the carton, carefully inspect the generator for
any damage that may have occurred during shipment.
If loss or damage is found at the time of delivery, have the
person(s) making the delivery notate the loss or damage on
the freight bill and affix his signature under the consignor's
memo of loss or damage. If the loss or damage is notated
after delivery, separate the damaged materials and then
contact the carrier for claim procedures. Missing or damaged
parts are not warranted.
Shipment Contents
The generator system is supplied with:
•
Oil (5W30 Full Synthetic)
•
Flexible fuel line
•
Quick Operation Manual
•
Product and emissions warranty booklet
•
Two access keys
•
Two 15 Amp ATO-type fuses
•
Four lifting hole caps
•
Touch up paint
•
Oil Warmer (pre-installed)
•
Two 1/4-20 screws (for enclosure anchoring for wind
rated areas)
Not included (You will need):
•
Carbon monoxide detector(s)
•
Smoke detector(s)
•
Starting battery
•
Connecting wire and conduit
•
Fuel supply valves/plumbing
•
Crane, lifting straps, chains or cables
•
Two 60" (152cm) lengths of 3/4" (1.9cm) nominal
minimum Schedule 40 steel pipe (NOT conduit)
•
Torque screwdriver, 5 to 50 inch-pound range
•
Multi-meter
7