Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Using a flathead screwdriver, 7/16" hex wrench
and the nut and bolt, secure the water connection
assembly. (See Figure 6)
Figure 6
Before operating, inspect for damage that may have
occurred during transit. Check guards to see if they are
securely fastened to the housing. Inspect power cords
for damage to the jacket.
Ensure that the power source conforms to the electrical
requirements of the motor (115 volt AC, 60Hz current,
1 phase 15 Amp. minimum) Follow all local safety
and electrical codes regarding power. Ground Fault
interruptor (GFI) circuitry is required. (Do not use
extension cords).
CAUTION!
• Do not operate fan while assembling.
• Disconnect from power when assembling, when
not in use or when performing maintenance.
• Do not use ground adapters.
• Do not exceed 45 PSI (+/- 2) of water pressure.
• When not in use, store fan under cover.
• Water filters require periodic cleaning. Disassemble
the water connection assembly to clean the filters.
PAGE 3 OF 9
ASSEMBLY CONTINUED
7.
Push hose onto barbed connector. (See Figure 7)
8. Tighten clamp over hose to secure. (See Figure 8)
Figure 7
SAFETY
• Do not kink cord or let it come into contact with
sharp edges, grease or chemicals.
• Do not use power cord for any purpose other than
the intended use.
• Turn fan "OFF" before connecting or disconnecting
from the power source.
• Unplug fan to move or service.
• Do not use any solid state speed control devices.
• Do not use in any flammable, explosive or
chemically-laden environment.
• Do not attempt to do any maintenance on this
motor. Any work could break water tight seals. Take
to authorized repair center.
MAINTENANCE
• Each nozzle on the misting head has a filter. These
filters need to be rinsed periodically with warm water
to remove mineral deposits that may form.
1-800-295-5510
uline.com
WARNING! Automatically operated device. To
reduce risk of injury, disconnect from power
source before servicing.
Figure 8
0921 IH-8549
Tabla de contenido
