Technical Data; Before Starting Work - Probuilder 43660 Manual De Instrucciones

Technical data

Mains connection
Motor power W
Operating mode
Compressor speed
Operating pressure
Lubrication type
Theoretical Suction capacity (l/min)
Protection type
Equipment weight in kg 4.7
Sound power level, L
wA
The noise emission values were determined
in accordance with EN ISO 3744.
Wear ear protection.
Exposure to noise can cause hearing loss.
220 V- 240V~ 50 Hz
max. 1100
S3(15%)
4300 min
-1
max. 8 bar
Oil-free
180
IP20
97 dB

Before starting work

Before connecting the device, verify that the
data on the type plate corresponds to the
mains data.
• Check the unit for transport damage.
Immediately report any damage to
the transport company with which the
compressor was delivered.
• The compressor must be set up near the
load that is to be powered.
• Avoid long air piping and long feed lines
(extension cords).
• Make sure that the inlet air is dry and
dust-free.
• Do not set up the compressor in a damp
or wet room.
• The compressor shall be operated in
suitable rooms (well ventilated, ambient
temperature +5°C to 40°C) only. The
room must not contain any dusts, acids,
vapors, explosive or in� ammable gases.
• The compressor is suitable for operating
in dry rooms. The compressor must not
be used in areas where splash-water is
used for work.
GB
73