Connecting The Device; Connect The Cables To The Zero Client - Fujitsu Zero Client DZ19-2 Manual De Instrucciones

Getting started

Connecting the device

Please observe the safety information in

Connect the cables to the Zero Client

1 = Threads for securing the swivel arm
or wall mounting
2 = Security slot for the "Kensington Lock"
3 = USB ports
4 = Power connection
5 = LAN port
► Insert the plug of the shielded Ethernet data cable in the LAN port of the Zero Client,
making sure that it the connector is correctly connected.
If you connect your Zero Client DZ22-2 to a Power over Ethernet network, no
mains cable is needed to supply power. This does not apply to the Zero Client
DZ19-2, which always needs a mains cable to supply power.
For power supply through Power over Ethernet (only for Zero Client DZ22-2):
Only use the Power over Ethernet Midspans provided by Fujitsu, as only
these can supply the required output of up to 60 W.
The Zero Client DZ22-2 must be switched off before the power supply source can
be changed from mains power to Power over Ethernet (or vice versa).
► Plug the other end of the Ethernet cable into a LAN wall socket.
► Insert the USB plugs of your keyboard and mouse into USB ports on your Zero Client.
Fujitsu Technology Solutions
2
"Important notes", Page 7 -
1
3
1
4
6 = USB ports
7 = Headphone output
8 = Microphone input
9 = DVI-D output
English - 15
English.
5 6 7 9 8
17