Step 2 - Installing The Sensor Pad - Angelcare AC1300 Manual Del Propietário

Ocultar thumbs Ver también para AC1300:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

STEP 2 - INSTALLING THE SENSOR PAD

4
5
6
Sensor Pad with pre-installed cord covers
2.1 - SELECT A LOCATION FOR THE NURSERY UNIT
Select a location for
the Nursery Unit that
is at least 3 feet [0.9
meter] away from
the crib.
IMPORTANT
Place the crib near a supporting wall and far from air currents. Install the Nursery Unit on a flat, stable
surface facing the crib at a distance of at least 3 feet (0.9 meter). Make sure to plug the adapter to the
socket outlet nearest to the equipment and that is easily accessible.
2.2 - SELECT THE CRIB LEG YOU WILL BE USING TO SECURE THE CORD COVERS
RECOMMENDED
6
5
4
Figure 1
1) Use the crib leg by the wall closest to the Nursery Unit (Figure 1). In cases where the
Nursery Unit is across the room, use the leg closest to the Nursery Unit to position the
covered wire (Figure 2). It is always preferable that the covered cord run along a wall.
2.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
2
1 Sensor Pad
or 2 Sensor Pads
(depending on model)
All manuals and user guides at all-guides.com
3
2
1
6
5
OR
3
2
1
3
5
4
6
Cord covers 1, 2, 3, 4:
Position on floor
Cord cover 4:
Contains double sided tape to
securely install beneath crib leg
Cord cover 5:
Position vertically between
mattress support and floor
Cord cover 6:
Place under the mattress
IMPORTANT
Keep
at least
3 ft (0.9 m).
4
3
2
1
6
4
3
2
1
Figure 2
1) Remove the mattress from
the crib.
3
2) Place the Sensor Pad(s) –
printed side up – on top
2
of the hardboard.
1
3) Run the connection pin,
warning label and the first
5 cord covers down along
the backside of the crib
leg, between the mattress
support and the inside
edge of the crib.
E
N
5
7

Capítulos

Tabla de contenido
loading

Tabla de contenido