Positioning The Movement Sensor Pad; Important - Angelcare AC417 Manual Del Proprietário

STEP 2 - POSITIONING THE MOVEMENT SENSOR PAD
2.1 - POWERING THE MOVEMENT SENSOR PAD
When using the Sensor Pad for the first time, you will need to insert the provided CR3032 battery.
2.2 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT

IMPORTANT

If your cot does not have a solid, stationary, completely flat, firm surface including a spring
or slat base, place a hard board between the crib base and the Sensor Pad, to ensure correct
operation.
The hardboard support must measure at least 33 x 33 cm (13" x 13") and 6 mm (1/4") thick.
This hardboard support must be larger than the Sensor Pad surface area.
The Sensor Pad functions with any size and type of mattress except memory-foam
mattresses, hollow frame mattresses and water beds. The hardboard maintains a constant
pressure on the Sensor Pad, enabling it to detect the baby's movements even when the baby
is at the edges of the cot.
Sensor Pad
IMPORTANT!
• Ensure the Sensor Pad is in the center of the Cot – printed or Logo side up – on top of the hardboard.
Check the position is central before each use.
• BEFORE FIRST TIME USE: To test that the unit is ready for use, refer to instruction manual on how to test
that the installation has been done correctly.
1) Remove the battery cover using a coin.
Turn in the direction of the arrow.
2) Place the included battery (CR3032) in
the compartment.
Note: The + symbol should be facing
up.
3) Replace the battery cover (the two
dots will line up). The Sensor Pad is now
Activated.
IMPORTANT: To prevent false alarms
we recommend that the CR3032 3V
battery is replaced every 4 months.
2
1) Remove the mattress from the crib.
2) Place the Sensor Pad - Angelcare
up - in the center of the mattress. It should be
centered on the hardboard if your crib requires a
hardboard support.
3) Replace the mattress.
E
N
Hardboard
logo side
®
5