Toshiba RAV-104NH Instrucciones De Instalación página 33

Heronhill - for all your Toshiba requirements
All manuals and user guides at all-guides.com
Location of Infra-Red Remote
Controller
Installing the Infra-Red Remote
Keep the remote controller where its signals
can reach the receiver of the indoor unit, a
!
distance of up to 7 metres is allowed.
When you select the timer operation, the
remote controller automatically transmits a
signal to the indoor unit at the specified time.
!
If you keep the remote controller in a position
that hinders accurate signal transmission, a
time lag of up to 15 minutes may occur.
Air Flow Adjustment
To improve the effects of cooling and heating, use the outlet louver appropriately for cooling and
!
heating operations. When in cooling operation the most efficient louver position will be horizontal,
and when in heating operation the optimum louver position is downwards.
The SH is different due to its installation position, in this case the above louver positions should be
!
reversed.
Increasing Heating Effect
One method to increase the warming effect is to fit an additional means of re-circulating the
!
warmed air from the upper part of the room;
However if the warming effect of the air conditioner is not good owing to the installation position or
the structure of the room, then reset the room temperature regulator as follows to raise the
!
temperature of the room. Adjust positions 1 and 2 on DIP switch SW03 located on the Indoor
PCB, according to the table below:
Dip Switch SW03
Positions 1 & 2
Temperature increased
Tel: 01823 665660
R C
EMOTE ONTROLLER
Infra-Red Remote Controller Mounting
A mounting fixture for the remote controller is
!
supplied.
When installing the mounting fixture, check
whether the remote controller signals from the
!
location where you will install the fixture can be
received by the indoor unit.
1 To mount, hold the remote controller parallel to
the mounting fixture and push it in fully.
2
and out from the mounting fixture.
I S E
MPROVING YSTEM
Position 1 : ON Position 1 : OFF Position 1 : OFF
Position 2 : OFF Position 2 : ON
Factory pre-set
~ 33 ~
www.heronhill.co.uk
To remove, slide the remote controller upwards
1
FFICIENCY
Position 2 : OFF
˚ ˚
+2 C +4 C
Fax: 01823 665807
2
GB