Daewoo International DTC-370 Manual De Instrucciones página 16

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

RINGING VOLUME
In on-hook state, press VOL key continuously to adjust the ringing volume, there are 4 levels can be select.
TRANSFER CALL FUNCTION
To transfer a call during a conversation to another phone number, press R key and dial the desired destination
number. When you hear the tone signal return the handset to the base to finish the call transfer.
FLASH FUNCTION
When you dialing a number and line is engaged, press FLASH key and then press REDIAL key to dial it out
again, or make another call.
PAUSE FUNCTION
If dial a number from PABX extension, press PABX number (normally "0" or "9") + VIP/P + desired number.
When redial, need not dial PABX number and VIP/P key, just press REDIAL key.
NOTES
Please unplug telephone line when install or replace batteries.
If at any time in the future you should need to dispose of this product please note that Waste
electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice. (Waste
Electrical and Electronic Equipment Directive)
TROUBLE SHOOTING
No voice
Check if the handset is on the phone or line is broken.
Receive only
Check if pulse or tone mode is properly set.
Check if the unit is locked, unlock it by the key.
Battery rust or leak
Replace the batteries.
Noise
Check if the circuit is broken, change the circuit.
Check if the connector is moist or rust, change the connector.
Ring once then disconnect when receive a call. Dialing function is available
Check if connector is in a moist environment.
Check if too many extensions are used together or the quality of extension is not good enough, change
the bad extension.
Most of the functions failed
Check if the battery is in low-battery state, change the battery.
Battery is in normal state, unplug the telephone line, remove the batteries, and reinstall after 10 minutes.
STATEMENT OF COMPLIANCE
Flamagas S.A. hereby declares that the DTC-370 product complies with the requisites and basic safety
requirements of Directive 1999/5/EC on Radio and Telecommunications Terminal Equipment.
For a full copy of the statement of compliance please see:
www.electronicaflamagas.com
All manuals and user guides at all-guides.com
DTC-370
16
Tabla de contenido
loading

Tabla de contenido