Getting Started; Setting Menu - Daewoo International DTC-360 Guia Del Usuario

GETTING STARTED

1. The unit requires 3×1.5V AA batteries. Open the battery compartment cover and insert the
batteries in the right polarity, then close the cover (Proposal using alkali battery). There should
be time display on the liquid crystal screen after the batteries are inserted.
2. Insert one end of the line cord to the line jack of the base and the other end to the wall outlet of
exchange.
3. Connect the handset and the base with coiled line.
4. Setting the dialing mode to correct mode according to the directions from your local telecom.
5. Apply for the caller ID service from your local telecom office.

SETTING MENU

At on-hook state, press SET/STORE/÷ key into the setting menu, LCD will display SET 1 DATE.
Use UP/－ or DOWN/+ key to select the submenu and press SET/STORE/÷ key to enter. At
setting course, press UP/－ or DOWN/+ key to change setting items and press SET/STORE/÷ key
to confirm. After finishing one submenu, press SET/STORE/÷ key to enter next. Press DEL key or
no operation within 10s, it will exit setting mode.
The detail item settings are as follow:
Setting date and time
1. At on-hook state, press SET/STORE/÷ key, LCD displays SET 1 DATE
2. Press SET/STORE/÷ key, the last two digits of year flash.
3. Press UP/－ or DOWN/+ key to edit the year. Press SET/STORE/÷ key to confirm and enter
month setting, use the same method to set the month, day, hour and minute.
Note: LCD will automatically display the corresponding week of the day.
When the unit is powered on initially, LCD will be reminded to set the date first. Use above
methods to set it, and then press SET/STORE/÷ key to come back to standby state.
Setting local area code
1. At on-hook state, press SET/STORE/÷ key and UP/－ key, LCD will display SET 2 CODE
2. Press SET/STORE/÷ key again, LCD displays CODE ----- or the preset local area code.
3. Press UP/－ or DOWN/+ key to set the first digit of local area code from 0 to 9.
4. Press SET/STORE/÷ key to confirm and enter the second digit setting. Use the same method
to set the last 4 digits. If the local area code has only 4 digits, the last digit can be left as "-".
Note: After setting the local area code, the phone can auto-filter local area code, and only display
the last digits of an incoming call number.
Setting PABX code
1. At on-hook state, press SET/STORE/÷ key and UP/－ key twice, LCD displays SET 3
PCODE.
2. Press SET/STORE/÷ to confirm, LCD displays PCODE - - or the preset PABX code.
3. The first "-" flashes to indicate to set the first code.
All manuals and user guides at all-guides.com
18