Wolf Garten POWER 34 Instrucciones De Funcionamiento Originales página 30

EN
Cleaning the grass collector (Fig. T V W )
Note
It is best to clean the grass collector directly
after mowing.
Raise the delector lap T 1 .
Î
Remove the grass collector T 2 .
Î
Lower the delector lap again T 3 .
Î
Empty the grass collector W 1 .
Î
Clean the fabric collection bag including the frame
Î
with water or a hand brush.
In particular, clean the area beneath the ill level
Î
indicator V 3 .
Allow the fabric collection bag to dry before the
Î
next use.
Transport and storage (Fig. X )
Risk of injuries due to the rotating mower
blade.
¾ Before transport or storage, switch off
the lawnmower and wait until the mower
blade comes to a standstill.
Switch the lawnmower off and wait until the motor
Î
blade comes to a standstill.
SAFETY ROUTINE
¾ Open the cover O 1 .
¾ Turn the safety key clockwise until it reaches
position "0" P 2 , then remove it.
¾ Use the power pack release device O 5 .
¾ Remove the power pack O 2 .
¾ Close the cover P 3 .
Secure the lawnmower suficiently to prevent its
Î
unintentional slipping if you are transporting it in or
on a motor vehicle.
To make it easier to stow the lawnmower, you can
Î
fold the handle together X .
To do this release the two upper quick release
Î
levers together with the threaded pins X 1 and
screw them out by approximately 5 mm. When
doing so hold the top part of the handle irmly, as
otherwise you could trap your hand or ingers.
Fold the top part of the handle down X 2 .
Î
Attention !
If you fold the handle bar forwards, the cable can
become damaged.
30
DANGER !
Release the two bottom quick release levers X 3 .
Î
Fold both handles forwards and support them on
Î
the front wheels of the lawnmower X 4 .
3 This allows you to easily carry the lawnmower via
its handle or to move it to a secure location for
storage X 5 (see arrow).
Storage during winter
Thoroughly clean your lawnmower after every
Î
mowing season.
Arrange for a specialist workshop to check your
Î
lawnmower in Autumn.
Store the lawnmower in a clean and dry room.
Î
Protect the lawnmower against rust during long
Î
storage periods in winter.
Never store the power pack inside the lawnmower!
Î
Replacing the mower blade (Fig. Y )
Risk of injuries.
¾ Arrange for a specialist workshop to
replace the mower blade.
¾ Only work on the mower if the motor is
stationary.
¾ War suitable safety gloves.
Switch the lawnmower off and wait until the motor
Î
blade comes to a standstill.
SAFETY ROUTINE
¾ Open the cover O 1 .
¾ Turn the safety key clockwise until it reaches
position "0" P 2 , then remove it.
¾ Use the power pack release device O 5 .
¾ Remove the power pack O 2 .
¾ Close the cover P 3 .
Attention !
Grinding the mower blade can result in an
imbalance. Have a specialist workshop check for
imbalance.
Note
To change the mower blade a torque wrench
with a 10 mm socket (M6) is required. Screw
tightening torque: 6–7 Nm Y .
WARNING !
72V Li-ION POWER 34-37-40
Servicing