Cleaning The Condenser; Removing And Cleaning The Interior Components - Kenmore 86482 Manual De Uso Y Cuidado

Cleaning the condenser

wWARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
1. Unplug ice maker or disconnect power.
2. Remove the two screws in the lower grille area and the
one screw from the center of the front panel support.
(Open bin door slightly for better access to the screw.)
Screw
3. Pull the bottom forward and then pull down to remove the
lower access panel.
4. Remove dirt and lint from the condenser fins with a soft
brush. Then use a vacuum cleaner with attachments to
remove the dirt from inside the unit compartment.
5. Replace the lower access panel and screws.
6. Plug in ice maker or reconnect power.
10
All manuals and user guides at all-guides.com
Screw
Screw
Removing and cleaning the
interior components
wWARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
1. Unplug ice maker or disconnect power.
2. Remove ice retainer baffle by flexing it to slide it off the
studs.
Thumb screws (long)
Cutter grid
front trim
3. Remove the water pan by unscrewing the two thumb
screws.
Water pan
Ice retainer
baffle
Thumb
Drain
screws
plug
(short)
Insert
into drain