Connecting The Monitor To A Computer - Sharp IT-23M1U Manual De Funcionamiento

Connecting the monitor to a computer

CAUTION!
- When connecting, ensure that the monitor and
all the equipment you are connecting to it are
switched off.
- Be careful not to over bend the cable or add
extension cords as this could lead to a
malfunction.
Notes:
- When using the monitor with an analog
connection, perform an automatic screen
adjustment (page E21) under the following
conditions:
- Using the monitor for the first time.
- After having changed the system settings
during use.
- When using the monitor with a digital
connection, automatic screen adjustment is
unnecessary.
- Depending on the computer or OS, you may
have to install the set-up information for the
monitor. (See page E37.)
- When connecting to a notebook and the
notebook computer's screen is set so that it is
displaying at the same time, the MS-DOS screen
may not be able to display properly. In this case,
change the settings so that only the monitor is
displaying.
IT-23M1U_gb_01.P65
All manuals and user guides at all-guides.com
E14
14
Analog connection
Connect the supplied PC analog signal cable to
the analog RGB output terminal of the computer.
See page E8 for information on removing/
replacing the terminal cover.
PC analog RGB input terminal
PC analog signal cable
(supplied)
- Paying attention to the connector direction, firmly
insert the signal cable straight into the
connector, and then tighten the screws at both
ends.
If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal
cable.
Power Macintosh
Macintosh conversion adapter
2004/08/20, 10:41
Analog RGB
output terminal